Push Plate made from solid steel. A clean, architectural plate designed for high-use doors without the stamped or decorative look. Built from solid steel flat bar, this is meant to read as permanent hardware — not an afterthought. At a Glance: Plate Width: 3" Material: Solid hot-rolled steel (3/16" thick) Mounting: 4-hole pattern, black Phillips screws included Use Case: Interior / exterior / commercial doors What makes this different: No stamping No hollow construction No cast decorative elements No thin sheet metal Just solid steel, cut and finished to hold up to daily use. The weight and surface of hot-rolled steel gives this a completely different feel from typical push plates — it reads as structural hardware, not a light-duty accessory. Design Notes: This plate is sized to pair cleanly with modern door pulls and bar handles. It can be matched to handle length for a consistent, architectural layout across the door. Works equally well in residential, loft, and commercial settings where durability and simplicity matter. Custom: Custom sizes and layouts are available — feel free to reach out if you’re matching an existing handle or working within a specific door layout.